Fast. Seitlich stehen die Versorgungspins etwas vor. Danke fürs Lob.Du hast da also Empfänger, Spannungsregler, Akkuwächter, Fahrtregler, Sound- und Lichtsteuerung auf dem Fußabdruck eines ESP32-Entwicklungsboards untergebracht.
Motor:What type of shaker motor do the gt power or mfc01 use
Bis jetzt sieht es sehr gut aus! Obwohl ich wieder die gehackte i6 verwende, habe ich nachLasst mich wissen, ob SBUS nun stabil ist.
Does yourWhere should I look?
src/4_adjustmentsTransmission.h
file contain the (not commented) line uint16_t lowRangePercentage = 58; ...
?After removing the // no compilation problem.
What do you mean with that?Now first to read carefully what it all says.
sbusFailsafeTimeout
didn't help.Keine Ahnung... Warum sollten sich verschiedene Receiver vom gleichen Hersteller anders verhalten??I wanted to check out the iA6B and another iA10B, but these two won't connect anymore,
Eben das wundert mich ja. Es ist aber tatsächlich so, dass die beiden wieder funktionieren, wenn ich zurück zu 9.9.0 gehe.Keine Ahnung... Warum sollten sich verschiedene Receiver vom gleichen Hersteller anders verhalten??
Versuch mal, den SBUS_PACKET_TIMEOUT in sbus.h zu erhöhen:
Kann ich überhaupt nicht nachvollziehen, da am "nicht embedded sbus" (mit der externen library) zwischen den beiden Versionen überhaupt nichts geändert hat. Bei mir funktioniert der A8S übrigens generell nur mit IBUS.Habe auch mal embedded SBUS ganz abgeschaltet, geht auch nicht (mit den beiden Empfängern).
Very good to know! The only idea I have now, is, that there are different firmwares for the iAxxB out there. I've tried different radios, checked the cables and settings, but they just won't get initialized. I guess, I simply move away from using them for this.Transmitter: I6X with original firmware in S-bus mode, receiver: IA6B
Thanks for testing.So no problems with this version.
Yes.Is this the right solution?
Danke.If you keep the button on the A8S pressed for a few seconds it will switch between SBUS and IBUS