redpiperbob
Mitglied
Sorry it is connected
Thanks
Bob
Thanks
Bob
This means:also if i Monitor the esp32 in the serial monitor i get
Offset CH 1 [microseconds]: -21
Offset CH 2 [microseconds]: 0
CH 3 signal out of auto calibration range, check transmitter & receiver
with the sticks at centre butif i move the ch1 stick iget the following.
CH4 is not able to auto zero, because it is not around center position. Please read the documentationjust noticed when I turn on the power the ESP red light is on all the time and the Blue light flashes 4 times then rests then 4times and so on
This version requires additional libraries:I compiled version 8.1
What to do with this warning.
This warning is not related to the LCD, it's related to the Neopixel LED library.fastspi.h:145:23: note: #pragma message: No hardware SPI pins defined. All SPI access will default to bitbanged output
The display remains blank.
Maybe another suggestion?
Schau doch mal hier:ich bitte um Hilfe
greatNeue Board Version 1.2 ist in Arbeit:
Den Anhang 108857 betrachten
- 5V Versorgung für LED und Verstärker mittels XM1584 Modul statt 7805 Regler, kann bis zu 3A liefern und wird nicht so heiss bei 3S Speisung
- Anhänger-Belegung mittels Lötbrücken umstellbar zwischen TAMIYA und meiner eigenen, die Seitenmarkierung und Rückfahrlampen einschliesst.
- Zusätzlicher Stecker für das Armaturenbrett-LCD
- Aussenmasse sind identisch, die LED-Stiftleisten sitzen jedoch ohne Lücken nebeneinander
- Sonstige Ideen?
sehr schön, können Sie der Batteriequelle des Moduls eine Schutzdiode hinzufügen, um eine Verpolung zu verhindern?Neue Board Version 1.2 ist in Arbeit:
Den Anhang 108857 betrachten
- 5V Versorgung für LED und Verstärker mittels XM1584 Modul statt 7805 Regler, kann bis zu 3A liefern und wird nicht so heiss bei 3S Speisung
- Anhänger-Belegung mittels Lötbrücken umstellbar zwischen TAMIYA und meiner eigenen, die Seitenmarkierung und Rückfahrlampen einschliesst.
- Zusätzlicher Stecker für das Armaturenbrett-LCD
- Aussenmasse sind identisch, die LED-Stiftleisten sitzen jedoch ohne Lücken nebeneinander
- Sonstige Ideen?