Hallo Norbert,welchen Vibrationsmotor (Shaker) hast du genommen?
Hallo Norbert,
Schwungmasse ist aus dem 3D Drucker . Die Datei wurde hier mal im Forum gepostet, ich finde den Post auf die Schnelle leider nicht, ich denke sie war von @TheDIYGuy999.
Hier sind die 3D Dateien...
Looks very god. How are you switching the trailer lights on and off during coupling / uncoupling? Is there a switch on the trailer, which is detecting the 5th wheel? Do you have detail pictures?Got my front trailer sorted.
versuch mal diesen Link anzuschauen.Hallo Emanuel,
welchen Vibrationsmotor (Shaker) hast du genommen? Ich bin noch auf der Suche und freue mich über Hilfe und Hinweise.
Die ich bestellt hatte waren viel zu klein.
Viele Grüße
Norbert
I put a limit switch underneath....but when I took the picture now I realised I fitted the "wrong" way round for when hooking on the trailer! I still want to fit one on the other side also to ensure a switch is closed no matter the angle of the truck.Looks very god. How are you switching the trailer lights on and off during coupling / uncoupling? Is there a switch on the trailer, which is detecting the 5th wheel? Do you have detail pictures?
The 5V supply to the lights only…The switch is switching an input on the trailer ESP32 or the battery?
4,6v on the board, just a BEC connected to the servo cable. After a few minutes the components on the board get really hot.If you have thermal problems, something is wrong with your wiring. Did you use series resistors for the LED? Also note, that the absolute maximum voltage for the PAM amplifier is 5.5V. Post a picture of your board.
What do you mean with really hot? The ESP32 always gets a bit warm, especially with WiFi enabled. The wiring looks OK as far as I can see.After a few minutes the components on the board get really hot.
Indeed Norbert. I had to pay a lot of import duties and VAT for the first version. The note from PCBWAY was more than doubled. When Martin approves his new boards I want to order a few here in Holland without components. I like The connector for the display haha. Can I immediately see if my soldering skills (over 60 years of experience) are still okay.Hallo Gerad,
sind das die Bauteile um die SMD-Platine selber zu bestücken?
Viele Grüße
Norbert